51 12 050 Removing and installing/replacing carrier for rear bumper trim

IMPORTANT: During replacement, all the cavities of the carrier (1) and the crashbox (2) must be sealed with cavity sealant.

Fig 1: Identifying Carrier And Crashbox

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

If necessary, release rubber mount (1) on carrier (2).

Unscrew nuts (3).

Remove carrier (2).

Tightening torque 51 12 1AZ , see 51 12 REAR BUMPER .

Installation:

If necessary, replace faulty sheet nuts (4).

Replacement:

If necessary, modify or replace weight on carrier (2).

Fig 2: Identifying Faulty Sheet Nuts

Courtesy of BMW OF NORTH AMERICA, INC.