51 71 482 Removing and installing/replacing left or right tension strut (on rear axle) (up to 03/2007)

IMPORTANT: Observe safety instructions for raising the vehicle. See 00 ... ... LIFTING VEHICLE WITH A LIFTING PLATFORM .
Driving without the tension strut is not permitted!

Release screws (1, 2, 3).

Remove tension strut (4).

Installation:

Replace screw (2).

Make sure screws are installed in correct positions.

Screw (1) M12x35
Tightening torque 51 71 25AZ, see 51 71 SEALS AND LOOSE BODY PARTS .
Screw (2) M12x50
Tightening torque 51 71 26AZ, see 51 71 SEALS AND LOOSE BODY PARTS .
Screw (3) M10x25
Tightening torque 51 71 20AZ, see 51 71 SEALS AND LOOSE BODY PARTS .

Fig 1: Identifying Tension Strut And Screws
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Left tensions strut (1) must be installed under right tension strut (2).

Fig 2: Identifying Left And Right Tension Strut Release Clips (1). Release Screws (2). Remove Underbody Cover (3).

Courtesy of BMW OF NORTH AMERICA, INC.