51 71 447 Removing and installing or replacing panel for cover on left or right side member

Necessary preliminary tasks:

Release expansion rivets (1) and screws (2).

Fig 1: Identifying Expansion Rivets And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at front.

Unclip rear panel (1) from holder (2).

Open door and remove panel (1) in direction of arrow.

Fig 3: Identifying Rear Panel From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on holder (2) must not be damaged.

Fig 4: Identifying Catches On Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, detach holders (1) from body and fit on panel (2).

If necessary, replace faulty holders (1).

Fig 5: Detaching Holders From Body And Panel

Courtesy of BMW OF NORTH AMERICA, INC.