66 12 100 Removing and installing/replacing slide-in unit for radio control key
Special tools required:
- 00 9 340
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Lever out trim (1) with special tool 00 9 340 at retaining points (2) in direction of arrow.
Release screws (1).
Pull back slide-in unit for radio control key (2) with associated ribbon cable.
IMPORTANT:
Carefully unlock ribbon cable plug connection.
Replace the ribbon cable if damaged.
The ribbon cable leads to:
Replace the ribbon cable if damaged.
The ribbon cable leads to:
- Control unit for Car Access System . See 61 35 015 REMOVING AND INSTALLING (REPLACING) CONTROL UNIT FOR CAR ACCESS SYSTEM .
- Start/Stop switch . See 61 31 023 REMOVING AND INSTALLING/REPLACING START/STOP SWITCH .
Remove slide-in unit for radio control key (2).