LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Suspension - Rear) >> Adjustments >> Ride Height

Ride Height

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Place 150 lbs. (68 kg) in each front seat and in the middle of the back seat. Place 46 lbs. (21 kg) in the trunk and ensure the fuel tank is full. Ensure correct tire pressure and that rims and tires are correct as specified by manufacturer. On vehicles with air springs, pull fuse of air supply system so that there is no regulation. Measure ride height from lower edge of wheel arch to bottom edge of wheel rim. Determine average value of each wheel after lifting and lowering vehicle body and then average each axle. If ride height is not within specification or deviates more than .4" (10 mm) between wheels, coil springs must be replaced. Replacement spring can be determined from parts microfiche, parts supplier, or on old spring at one end. On vehicles with air suspension, perform height setting offset (refer to BMW Diagnosis System). For correct ride height see RIDE HEIGHT SPECIFICATIONS  table.

RIDE HEIGHT SPECIFICATIONS

Application In. (mm)
17" Rim 25.2 (640)
18" Rim 25.7 (653)
19" Rim 26.2 (666)
20" Rim 26.7 (679)