Removal & Installation of Quick-Release Coupling with Indication Pins
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 BMW 745i, 2004 BMW 745Li, 2003 BMW 745i, 2003 BMW 745Li, and 2002 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Coupling is not correctly engaged if both indication pins (4) fail to protrude from housing. Leakage will occur. See Fig 1.
- Press plastic ring (2) into quick-release coupling (1) and remove coupling (1). See Fig 1.
- To install, push quick-release coupling (1) onto connector (3) until both indication pins (4) can be seen and felt to point outwards at outside diameter of housing. To check that quick-release coupling (1) has been correctly fitted, feel indication pins (4) at outside diameter of housing. When correctly seated, indication pins (4) cannot be pressed into housing.