36 11 533 Removing and installing / replacing RDC wheel electronics: Notes
WARNING: This page is about a different car, the 2005 BMW 745i, 2004 BMW 745i, 2003 BMW 745i, and 2002 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a Tyre sealing fluid has been used, replace the wheel electronics.
When a Tyre has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
When a Tyre has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
IMPORTANT:
If the wheel electronics have been removed, the complete valve must be replaced.
Necessary preliminary tasks:
Remove Tyre. Refer to 36 12 001 CHANGING A TIRE (ON FRONT, REAR OR SPARE WHEEL) or 36 12 001 REPLACING A TIRE (RUN FLAT) .
Follow instructions on initializing Run Flat Indicator. Refer to 36 11 000 INITIALIZING TYRE DEFECT INDICATOR (RPA) .