12 13 511 Replacing ignition coil (N62)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.

Switch off ignition.

Remove acoustic cover.

Pull ignition coil covers (1) out of rubber grommets.

Fig 1: Removing Ignition Coil Covers

G03289782

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug fastener (1) of ignition coil.

Fig 2: Releasing Ignition Coil Plug Fastener

G03289783

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug.

Fig 3: Removing Ignition Coil

G03289784

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out ignition coil (2).

This procedure is applicable to all ignition coils.

Installation:

Insert rubber seal on ignition coils (2) between guides.

Fig 4: Inserting Rubber Seal On Ignition Coils Between Guides

G03289785

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.