11 37 008 Removing and installing/replacing right eccentric shaft (N62 to 9/03): Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
(cylinder bank 1 to 4)
Remove servomotor for right eccentric shaft.
Remove ignition coils on cylinder bank 1 to 4.
Remove spark plugs on cylinder bank 1 to 4.
Remove right cylinder head cover.
Install inlet and exhaust adjustment unit on right side.
Remove right inlet camshaft. Refer to 11 31 034 Removing and installing/replacing right inlet camshaft (N62 from 9/03) .
IMPORTANT:
Eccentric shafts up to 2/2003:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are different and must not be mixed up. The side of the eccentric shaft on which the lever for the torsion spring is fitted must not be mixed up.
Eccentric shafts from 2/2003:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are identical parts.
Depending on the side on which the lever for the torsion spring and the magnet wheel are fitted, the eccentric shafts are used for cylinders 1 to 4 or 5 to 8.
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are different and must not be mixed up. The side of the eccentric shaft on which the lever for the torsion spring is fitted must not be mixed up.
Eccentric shafts from 2/2003:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are identical parts.
Depending on the side on which the lever for the torsion spring and the magnet wheel are fitted, the eccentric shafts are used for cylinders 1 to 4 or 5 to 8.