16 14 Fuel Pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW Z4, 2007 BMW Z4, 2006 BMW Z4, 2005 BMW Z4, and 2004 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
16 14 FUEL PUMP TIGHTENING SPECIFICATION
| Application | Type | Thread | Tightening specification | Measure |
|---|---|---|---|---|
| 1AZ Fuel level sender to fuel intake | All / with transfer pump in tank | 2 Nm | ||
| E32 | 8 Nm | |||
| 2AZ Sealing ring for fuel tank (service aperture, fuel level sensor, pump unit) | ||||
| Plastic sealing ring 26.5 mm high | E34 / E31 | 40 Nm | ||
| Plastic sealing ring 31.5 mm high (new) | E36 / E34 / E31 | First tighten sealing ring by hand 2 turns | 55 Nm | |
| Locking ring (metal) | E39 / E52 / E53 | 35 Nm | ||
| v |
E60 / E61 / E63 / E64 / E65 / E66 / E67 | 45 +/- 5 Nm | ||
| E85, | 50 +/- 10 Nm | |||
| E83 | 55 +/- 5 Nm | |||
| 3AZ In -tank pump with fill level sensor to tank | E38 | M6 | Tighten nuts diagonally and evenly. | 6.5 Nm |
| 4AZ El. fuel pump control unit to body / holder | E60, E61 | M6 | 8 Nm |