11 11 Engine Block, Cylinder Crankcase N62 B44
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 BMW 745i, 2005 BMW 745Li, 2004 BMW 745i, 2004 BMW 745Li, and 2003 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE BLOCK, CYLINDER CRANKCASE N62 B44 SPECIFICATIONS
| Bore PHY stage 0 (1) | mm | 92.000 +0.014 | ||
| Bore PHY stage 1 (1) | mm | 92.250 +0.014 | ||
| Bore PHY stage 2 (1) | mm | 92.500 +0.014 | ||
| Permitted out-of-round of cylinder bore a) | mm | 0.007 | ||
| Permitted conicity of cylinder bore (1) | mm | 0.01 | ||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 | ||
|
||||