LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Suspension - Front) >> Removal & Installation >> Front Active Stabilizer Bar >> Installation

Front Active Stabilizer Bar: Installation

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check antifriction bearing. Replace if necessary. Tighten screws on antifriction bearings to specification. See TORQUE SPECIFICATIONS  .
  2. Install left and right stabilizer. Replace self-locking nut and tighten to specification. See TORQUE SPECIFICATIONS  .
  3. Install oscillating motor and tighten screws to specification. See TORQUE SPECIFICATIONS  .
  4. Perform initial operation of dynamic drive. See INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE  .
scientia non olet · About LEMON Manuals