32 41 100 Removing And Installing/Replacing Belt Pulley On Vane Pump For Power Steering

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Carry out preliminary work as described in the document "Replacing drive belt". Refer to 11 28 010 REPLACING ALTERNATOR DRIVE BELT (N62/N62TU) .

Slacken bolts (1)

Fig 1: Removing Belt Pulley

Courtesy of BMW OF NORTH AMERICA, INC.

Relieve tension on drive belt and remove from belt pulley (2).

Unscrew bolts (1) and remove belt pulley (2).

Installation:

Lettering on belt pulley (2) points forwards.

Tightening torque, 32 41 14AZ. Refer to STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .