11 37 040 Removing and installing/replacing right eccentric shaft sensor (N62)
WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
(cylinder bank 1 to 4)
Remove right cylinder head cover.
Unfasten screws.
Remove eccentric shaft sensor (1).
Installation:
Read out fault memory of control unit of Digital Motor Electronics (DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.