00 00... Front and rear brake linings: checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings: Notes

WARNING: This page is about a different car, the 2006 BMW X5, 2005 BMW X5, and 2004 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Check brake lining thicknesses with measuring gauge at front and rear. For subsequent procedure, refer to BRAKE SPECIFICATIONS .

NOTE: Issue a separate invoice for replacing the brake linings.

Remove front and (if necessary) rear disk brake linings. For further information on how to proceed, refer to BRAKE DISC PADS .

NOTE:

Replace brake linings if they drop below minimum thickness (refer to BRAKE SPECIFICATIONS ).
Replace brake disks if they drop below minimum thickness (refer to BRAKE SPECIFICATIONS ) and in event of scoring, heat cracks, lateral runout or thickness difference.
Apply a thin coat of grease to wheel centering on light alloy wheels, refer to BRAKE SPECIFICATIONS .