LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Maintenance And General Information - Repair) >> 00 ...... Raising Vehicle With Trolley Jack (Vehicle Equipped With Jacking Point)

00 ...... Raising Vehicle With Trolley Jack (Vehicle Equipped With Jacking Point)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2007 BMW M6, 2007 BMW 650i, 2006 BMW M6, 2006 BMW 650i, and 2005 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Vehicles without jacking points (located in the middle of the front axle carrier) must not be raised or moved with the trolley jack! Use only BMW-distributed/approved trolley jacks which have rubber plate contact points. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used! To prevent the vehicle from slipping off the trolley jack, check the rubber plate for damage prior to each use.

Raising vehicle at front:

If necessary, remove front spoiler/spoiler lip.

Slide trolley jack under vehicle at front middle until the rubber contact plate is situated below the jacking point.

Raise vehicle with trolley jack.

Fig 1: Locating Jacking Point
G03286007Courtesy of BMW OF NORTH AMERICA, INC.

Raising vehicle at rear:

IMPORTANT: Risk of damage: Raising the vehicle at the rear differential is not permitted!