65 75 071 Removing and installing (replacing) module for passenger compartment sensor

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Lever out trim (1) with special tool 00 9 340 (removal aid) and remove.

Fig 1: Identifying Lever Out Trim With Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove module for passenger compartment sensor with trim.

Replacement:

Open retaining lugs (2) and remove module (3).

Installation:

Arrow (4) printed on module for passenger compartment sensor must be aligned in direction of arrow.

Fig 2: Identifying Plug Connection And Retaining Lugs With Module

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .