61 31 334 Removing and installing/replacing grip trim for gear selector switch

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.

Lever off side section (1) with special tool 00 9 322 from gear selector switch (2) and remove.

Installation:

Position side section (1) on metal pins of gear selector switch (2) and uniformly press down firmly and without leaving a gap.

Fig 1: Identifying Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Lever off front shell (1) with special tool 00 9 322 from gear selector switch (2) and remove.

Press P button (3) and remove front shell (1) starting from top.

Installation:

Insert front shell (1) at bottom in retaining ring (4). Uniformly press front shell (1) upwards onto metal pins of gear selector switch (2) firmly and without leaving a gap.

Fig 2: Identifying P Button, Front Shell And Gear Selector Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Lever off P button (1) with special tool 00 9 322 from gear selector switch (2) and uniformly remove.

Installation:

After installing front shell, insert P button (1) into upper opening on gear selector switch and uniformly press in until it engages.

Fig 3: Identifying P Button And Gear Selector Switch

Courtesy of BMW OF NORTH AMERICA, INC.