61 31 220 Removing and installing/replacing multifunction steering wheel switch (from 03/2007)

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove AIRBAG UNIT

Release screws (1).

Disconnect plug connection (2).

Remove retaining plate (3) from steering wheel.

Installation:

Make sure electrical leads are correctly routed.

Fig 1: Identifying Retaining Plate, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Illustrations depict removal of the left multifunction steering wheel switch. The right multifunction steering wheel switch is removed in the same way.

Release screws (1).

Unclip multifunction steering wheel switch (2) at point (3).

Disconnect associated plug connections and remove multifunction steering wheel switch (2).

Installation:

Make sure guide pins (4) are correctly seated.

Fig 2: Identifying Multifunction Steering Wheel Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe the following work steps to adjust the correct gap dimensions between decorative strips and airbag unit.

Fit airbag unit (1) on steering wheel retaining plate (2)
Align switches (3)
Tighten screws (4).

Fig 3: Identifying Steering Wheel Retaining Plate, Switches And Screws
Courtesy of BMW OF NORTH AMERICA, INC.