LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (General Electrical System - Repair) >> Switch >> 61 31 079 Removing and installing/replacing switch for hazard warning flashers/central locking

61 31 079 Removing and installing/replacing switch for hazard warning flashers/central locking

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Risk of damage!

Protect middle fresh-air grille decorative trim in working area against damage, tape off if necessary.

Lever out switch for hazard warning system/central locking (1) with special tool 64 1 020 and pull back.

Disconnect associated plug connection and remove switch for hazard warning system/central locking (1).

Fig 1: Removing Switch For Hazard Warning System/Central Locking
G03262205Courtesy of BMW OF NORTH AMERICA, INC.