61 20... Threshold values for battery inspection of all battery (telephone except for telephone battery)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.
Safety instructions for handling vehicle battery.
Test step 1 - before charging the battery
TEST STEP 1
| State of charge() | Start output() | Test result |
|---|---|---|
| cannot be tested | Charge | |
| less than 50 %() | Charge | |
| greater than 50 % | less than 75 % | Charge |
| greater than 50 % | greater than 75 %() | Charge |
| greater than 80 % | greater than 75 % | O.K. |
Test step 2 - after charging the battery
TEST STEP 2
| State of charge() | Start output() | Test result |
|---|---|---|
| cannot be tested | Faulty | |
| less than 50 % | less than 75 % | Charge |
| greater than 50 % | greater than 75 % | Charge |
| () | State of charge and start output must always be evaluated in combination |
| () | Test charging for more than 5 hours with Gossen CG 32 or Siemens / Gossen VB 801 charger |
| () | Fully charge until the state of charge is greater than 80% |
NOTE:
If the battery has been tested from the positive terminal in the engine compartment, repeat the test for safety directly on the battery.