54 12 117 Replacing seal for glass slide/tilt sunroof lid
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Follow REPAIR INSTRUCTIONS for bonded seals on slide/tilt sunroof
- Open glass lid completely
Start removal at contact edge (rear center):
- Peel off rubber seal
- Clean bonded area
Installation:
Also start at specified point of contact edge for installation:
- Stick on rubber seal in stages
- Establish seal joint
- Press on seal