65 20 030 Removing and installing/replacing empty housing for roof-mounted aerial

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

65 2 010

WARNING: Risk of injury!
Special tool has sharp edges!
Adapt working height to vehicle height with non-tilting and non-slip platform.
Handle special tool correctly and make sure it is positioned without tilting or slipping on the vehicle.
Special tool 65 2 010 is only permitted in conjunction with a suitable stepladder.
Risk of damage!
In order to prevent dents in the roof, do not exert any pressure on the roof.

IMPORTANT: Note to customer:
In order to guarantee a permanent connection and adhesive curing:
After bonding the empty housing for the roof-mounted aerial, wait 24 hours before driving the vehicle through a car wash.

NOTE: Clean roof.

Mask roof (2) around empty housing for roof-mounted aerial (3) with yellow plastic adhesive tape (1). To do so, slide plastic adhesive tape under empty housing (3) slightly.

Fig 1: Identifying Roof, Adhesive Tape And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Make sure your arms do not cross over (1) when holding special tool 65 2 010 .
Pull handle must always be ahead of the guiding hand (2).

Fig 2: Identifying Proper Position Of Holding Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
To avoid damaging the paintwork on the roof and empty housing (3), do not fit special tool 65 2 010 skew.

Cut through adhesive bead all round with special tool 65 2 010 .

Pull on handle (1) and align blade on handle (2).

NOTE: Use sharp blades only. Replace blade if necessary.

Fig 3: Cutting Adhesive Bead Using Special Tool (65 2 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Remove empty housing (3).

Installation

Empty housing for roof-mounted aerial is secured with window glass adhesive. All preparatory operations correspond to the WINDOW CEMENTING INSTRUCTIONS .

NOTE: Replace empty housing for roof-mounted aerial if centering pins (1) on empty housing are damaged.
Bonding surface (2) must be clean and free from grease.

Fig 4: Identifying Centering Pins And Bonding Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Position two spacers (1) on cleaned empty housing.

Dimensions:

10 mm
14 mm

Position spacer (2) centrally and flush with shoulder of adhesive flange.

IMPORTANT: Use spacers without fail!

Fig 5: Identifying Spacers

Courtesy of BMW OF NORTH AMERICA, INC.

Apply trace of adhesive bead all round outer contour as follows.

Distance between adhesive bead and edge of aerial cover:

6.5 mm ±1 mm

Start and end of bead trace must have an overlap length of max. 10 mm.

Fig 6: Applying Trace Of Adhesive Bead All Round Outer Contour

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To prevent the adhesive from escaping, the adhesive bead diameter must not exceed max. 1.5 mm to 2.5 mm.

NOTE: Attach the empty housing coated with adhesive by hand. To spread the adhesive better, move the housing back and forth horizontally slightly when pressing down.

Secure empty housing if necessary with adhesive tape and press down uniformly.

After bonding, leave vehicle to stand for at least 3 hours at room temperature.