63 14 060 Removing and installing/replacing front left or right side marker

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 323

Necessary preliminary tasks

Remove FRONT WHEEL ARCH COVER FRONT SECTION .

NOTE: Minimum object temperature of side marker and side panel ≥ 18 °C.
If this temperature is not achieved, the components must be preheated.

Removing side marker

Carefully heat side marker (1) in area (A) with hot air blower and detach with special tool 00 9 323 from side panel (2).

NOTE: Side marker (1) cannot be reused.

Fig 1: Disconnecting Heat Side Marker From Side Panel Using Special Tool (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Cleaning side panel

For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.

Clean adhesive area of side panel with spirit.

Air drying time at least 1 minute.

Do not grip bonding surface.

Fitting side marker

Pull off liner* (1) and gently press side marker (2) onto side panel.

Check position and if necessary realign. Minimum application pressure is achieved by applying firm thumb pressure in stages over the entire joining surface (hold time approx. 1 second).

Firm thumb pressure approx. 35 N/cm² .

* Liner is the protective film on a new side marker.

Fig 2: Identifying Liner And Side Marker

Courtesy of BMW OF NORTH AMERICA, INC.