65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove FRONT LEFT WHEEL ARCH COVER .

NOTE: On RHD vehicles remove FRONT RIGHT WHEEL ARCH COVER .

Release screws (1) and remove cover (2).

Installation note:

Make sure rubber grommet (3) is correctly seated.

Fig 1: Identifying Rubber Grommet, Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove housing (2) and disconnect associated plug connection.

Fig 2: Identifying Housing And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Release nut (1) and remove emergency power siren with tilt alarm sensor (2).

Fig 3: Identifying Alarm Sensor And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Guides (1) of emergency power siren (2) must be correctly seated in area (3) of holder (4)!

Fig 4: Identifying Emergency Power Siren, Guides And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .