54 10... Overview 3D animation mechanism glass slide/tilt sunroof cover
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Also comply with the interactive 3D instructions for the removal and installation of the glass slide/tilt sunroof cover mechanism. It does not replace but enhance the applicable repair instructions. Press the individual point for animation display of the corresponding operations.
- 3D animation mechanism glass slide/tilt sunroof cover
| Operation number: | Description: |
|---|---|
| 1 | Remove front water channel |
| 2 | Move mechanism forward |
| 3 | Remove front powertrain glass slide/tilt sunroof cover |
| 4 | Remove retaining rail |
| 5 | Move front carriage |
| 6 | Remove front gate |
| 7 | Move front carriage (until drive wedge is exposed) |
| 8 | Remove drive wedge |
| 9 | Remove front carriage |
| 10 | Remove front drive cable tray |
| 11 | Remove rear water channel carrier |
| 12 | Move rear carriage |
| 13 | Remove rear gate |
| 14 | Remove spring retainer |
| 15 | Remove service carriage |
| 16 | Remove rear drive cable tray |
| 17 | Install rear drive cable tray |
| 18 | Install service carriage |
| 19 | Install spring retainer |
| 20 | Install rear gate |
| 21 | Move rear carriage |
| 22 | Install rear water channel carrier |
| 23 | Install front drive cable tray |
| 24 | Install front carriage |
| 25 | Install drive wedge |
| 26 | Move front carriage (drive wedge locks in front carriage) |
| 27 | Install front gate |
| 28 | Move front mechanism (front gate locks in drive wedge) |
| 29 | Install retaining rail |
| 30 | Fasten retaining lug to front gate |
| 31 | Perform basic setting |
| 32 | Install front powertrain |
| 33 | Function check (synchronization check) |