26 11 051 Replacing flexible disc for front propeller shaft

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PROPELLER SHAFT from transmission and center mount

NOTE: To protect universal joints, tie back propeller shaft in area of center mount.

Release screws and remove flexible disc (1) from propeller shaft.

IMPORTANT: Replace shiny ZNS bolts and self-locking nuts.

Tightening torque and angle of rotation: 26 11 1AZ .

Installation note

Arrows (3) on circumference of flexible disc must point to flange arms (2).

Fig 1: Locating Propeller Shaft Flexible Disc Mounting Screws
Courtesy of BMW OF NORTH AMERICA, INC.
Grip mounting bolts of flexible disc at propeller shaft flange at nuts and tighten down at bolt heads.

Installation note

Check centering mount.

Replace damaged CENTERING MOUNT .

Grease centering mount.

Fig 2: Locating Centering Mount

Courtesy of BMW OF NORTH AMERICA, INC.