51 24 280 Removing and installing/replacing bottom left or right lock support for rear lid

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove TRIM ON D-PILLAR AT BOTTOM .

Open rear lid (1) only until screw (2) is accessible (risk of injury by spring tension).

Release screw (2) with rear lid in this position.

Tightening torque 51 24 7AZ .

Fig 1: Identifying Rear Lid And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove support (2).

Tightening torque 51 24 7AZ .

Fig 2: Identifying Rear Lid Lock Support And Screw

Courtesy of BMW OF NORTH AMERICA, INC.