51 16 165 Removing and installing/replacing complete center console

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove SIDE CARPET FROM STORAGE COMPARTMENT on left and right.
Remove FRESH AIR GRILLE IN REAR CABIN .
Remove GEAR SELECTOR SWITCH SUPPORT (not when releasing center console. )
Remove AV CONNECTING SOCKET COVER (not when releasing center console. )

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES and cables.

NOTE: Driver's seat removed for purposes of clarity.

Release screws (1) and (2) on left and right.

Removing torque 51 16 4AZ .

Fig 1: Identifying Centre Console Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and pull center console (2) approx. 50 mm towards rear.

Tightening torque 51 16 4AZ .

NOTE: The operation Releasing center console ends here.

Version with rear compartment monitor:

Disconnect plug connection (3).

Fig 2: Identifying Centre Console, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Feed air duct (1) out of center console (3).

Release cable clip for cable (2) from center console (3).

Installation note:

Make sure air duct (1) is correctly seated on center console (3).

Fig 3: Identifying Air Duct, Centre Console And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Fig 4: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Version with eject box:

Expose plug connections for EJECT BOX wiring harness and disconnect.

Pull center console (1) towards rear/top, feed out wiring harnesses (2) and (3), and remove center console (1).

Fig 5: Identifying Centre Console And Wiring Harnesses

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove REAR COMPARTMENT MONITOR .

Remove REAR STORAGE BOX .

Remove SIDE COVER ON CENTRE CONSOLE .

Remove FRONT CUP HOLDER .