12 61 280 Removing and installing/replacing oil pressure sensor (N63, S63)
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Turn off ignition
- Remove REINFORCEMENT PLATE .
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Recycling
Catch and dispose of drained engine oil in a suitable container.
Observe country-specific waste-disposal regulations.
Installation location
Oil pressure sensor is located next to the oil filter housing.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release and remove oil pressure sensor (2).
Tightening torque 12 61 1AZ .
Installation:
Check engine oil level. Top up engine oil if level is too low.