11 36 048 Removing and installing/replacing inlet and exhaust adjustment units on right side (S63): Notes
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
When the engine is shut down, the inlet and exhaust adjustment unit is normally locked in its initial position.
The situation may arise in some individual cases where this initial position is not reached and the camshaft can continue to be rotated in the adjustment range of the adjustment unit.
Where central bolts are not greased at the bolt contact points up to engine number 20024295 , the adjustment gear must be replaced for safety reasons.
The central bolts is greased from engine number 20024296 .
The situation may arise in some individual cases where this initial position is not reached and the camshaft can continue to be rotated in the adjustment range of the adjustment unit.
Where central bolts are not greased at the bolt contact points up to engine number 20024295 , the adjustment gear must be replaced for safety reasons.
The central bolts is greased from engine number 20024296 .