Bleeding front axle brake circuit
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Connect vent hose with collecting vessel to vent valve on front right brake caliper.
Close vent valve.
Run brake bleeding procedure with DIS with vent valve open.
After completing routine, press brake pedal 5 times to floor, clear and bubble-free brake fluid must flow out.
Close vent valve.
Repeat procedure at front left.
Switch off brake fluid changer and remove from expansion tank.
Check brake fluid level. If necessary, top up/draw off to max. level.
Close expansion tank.
NOTE:
Pay attention to rubber seal (1) in sealing cap.