13 54 020 Removing and installing/sealing right throttle body (N63, S63)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Turn off ignition.
Remove right INTERCOOLER .

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Fig 1: Identifying Throttle Valve Assembly, Coolant Remnants Plug Connection And Mounting Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check plug connection (1) for coolant remnants. Clean soiled plug connection (1) with compressed air.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Throttle Assembly Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault message.

Delete fault memory.