61 12 200 Replacing wiring harness in left or right front door

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES and cables.

Necessary preliminary tasks

Close front side window completely
Remove FRONT SOUND INSULATION

NOTE: Work is shown on the E70 by way of example. There may be differences in detail from other vehicle models and equipment specifications.

Disconnect plug connection (1).

If necessary, disconnect plug connection for sensor on front door See 65 77 740 REMOVING AND INSTALLING (REPLACING) LEFT FRONT DOOR SENSOR or 65 77 745 REMOVING AND INSTALLING/RENEWING RIGHT FRONT DOOR SENSOR .

Release all attachment points (2) of door wiring harness.

Fig 1: Identifying Door Wiring Harness Attachment Points And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Front side panel shown removed for purposes of clarity.

Release screw (1), fold door wiring harness plug on A-pillar (2) downwards slightly and remove in direction of arrow.

Disconnect associated plug connection.

Pull rubber grommet (3) in direction of arrow out of front door (4).

Fig 2: Pulling Rubber Grommet Out Of Front Door

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out door wiring harness towards front to A-pillar and remove.