Necessary preliminary work

WARNING: This page is about a different car, the 2010 BMW M6, 2009 BMW M6, 2008 BMW M6, 2007 BMW M6, and 2006 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Remove transmission.
Remove clutch release bearing.

Release bolts (1) and remove guide tube (2).

Fig 1: Identifying Guide Tube And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The shaft seal and the guide tube are replaced together.

Installation note:

Wrap adhesive tape round keyway splines of drive shaft to avoid damaging the sealing ring while it is being installed.

Lubricate sealing lip of sealing ring.

Replace mounting bolts of guide bush.

Tightening torque, see MANUAL TRANSMISSION - TIGHTENING TORQUES .