0491507 231300 Device Minimum set: Mechanical tools MW

WARNING: This page is about a different car, the 2010 BMW M6, 2009 BMW M6, 2008 BMW M6, 2007 BMW M6, and 2006 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For fitting output flange on all manual and automatic transmissions, for installing deep grooved ball bearing on transmission output shafts and for fitting drive flange on all rear axle final drives

Storage Location

C17

Consisting of:

1 = 0491508 Adapter

3 = 0493256 Mandrel

2 = 0491509 Washer

NOTE: (Support disc) For pressing the drive flange onto the rear axle final drive

Fig 1: Identifying Device (231300)

Courtesy of BMW OF NORTH AMERICA, INC.