64 12... Replacing burner insert for independent heater

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, and 2008 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Scalding hazard!
Carry out following tasks after engine and independent heater have cooled down.
Follow instructions for working on cooling system! See 17 00... INSTRUCTIONS FOR WORKING ON COOLING SYSTEM .

IMPORTANT: The burner insert may only be replaced after the 24-month warranty period has elapsed.
The entire independent heater must be replaced during the warranty period.

Necessary preliminary tasks:

Remove complete independent/auxiliary heater

Release screws (1) and remove bracket (2) from heater.

Tightening torque 64 12 2AZ

Fig 1: Identifying Screws And Heater Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamp (1) on hose for circulating pump and disconnect hose.

Release hose clamp (2) on intake filter hose and disconnect hose.

Installation:

Check all water hoses for damage, replace if necessary.

Fig 2: Identifying Hose Clamp On Intake Filter Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully lift cover (1) off heater.

Fig 3: Lift Cover Off Heater

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Fig 4: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Fig 5: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 64 12 3AZ

Replace all screws.

Carefully lift out combustion air blower unit (2).

Fig 6: Identifying Combustion Air Blower Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and pull out burner insert (3) with grommet (2).

Replace all screws.

Tightening torque 64 12 4AZ

Installation:

Make sure grommet (2) is in correct installation position.

Fig 7: Identifying Screws, Burner Insert And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace seals (1, 2) and clean sealing surfaces thoroughly.
If necessary, remove soot deposits.
To prevent the fuel pipe on the burner element being damaged, coat seal (2) with spirit when fitting housing.

Fig 8: Identifying Seals
Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and vent cooling system and check for leaks See 17 00 039 VENTING COOLING SYSTEM AND CHECKING FOR LEAKS .