64 12... Initializing Telestart hand-held transmitter (T93) (from version 03/2007 onward)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, and 2008 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Telestart hand-held transmitter must be initialized after:
- Hand-held transmitter is replaced
- Car Access System control unit is replaced
The auxiliary heating is switched on under an ambient temperature of approx. 15 °C with the hand-held transmitter and at a preselected switch-on time. Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
- Close all vehicle doors
- Insert radio-operated key into shaft and immediately remove again, switch d.h. terminal R on and off (max. switched-on period 5 s)
- Within 10 s, simultaneously press the ON button and the OFF button for 3 s. The indicator light (LED) lights up orange.
- Release both buttons.
- Within 10 s (while the indicator light is lit) operate the ON button briefly three times. The indicator light flashes orange (approx. 1.5 s long).
- The central locking signals successful initialization of the Telestart transmitter by immediately locking and unlocking.