41 13 510 Replacing Left Equipment Carrier Partition Wall (Wheel Arch Removed)

Read contents of BODY, GENERAL  and observe relevant procedures.

The weight-reduced aluminum front end structure (GRAV) is used on this vehicle.

Following new body parts are required:

• Complete partition wall reinforcement
• Shaped part, partition wall, equipment compartment (not shown)
  Fig 1: Identifying Partition Wall Reinforcement

  Courtesy of BMW OF NORTH AMERICA, INC.

Open rivet joints in areas (1) to (3).

Open EMC WELD SEAM  in area (5).

Installation: 

Use 4 rivets (size 13) in area (1).

Use 1 rivet (size 13) in area (2).

Use 1 rivet (size 13) in area (3).

Use 1 rivet (size 13) additionally in area (4).

Use 2 EMC SCREWS  additionally in area (1).

Fig 2: Identifying Rivets Installation Area (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Open rivet joints in areas (1) and (2).

Open EMC WELD SEAM  in area (3).

Installation: 

Use 3 rivets (size 13) in areas (1).

Use 4 rivets (size 13) in area (2).

Use 2 EMC SCREWS  additionally in area (2).

Carry over holes for rivets to new part. Adjust new part together with wheel arch to fit and secure.

Drill through both parts together.

Stick on CAVITY ACOUSTIC BAFFLE  all round with window glass adhesive in area (4).

Bond  new part.

Rivet  new part.

Fig 3: Identifying Rivets Installation Area (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.