51 24 326 Removing And Installing / Replacing Left Tension Spring With Damper For Rear Lid

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove right LUGGAGE COMPARTMENT WHEEL ARCH TRIM .

WARNING: Support rear lid in fully opened position with suitable apparatus. Risk of injury.

Pull off retainer (1) upwards.

Pull off tension spring with damper (2) in inwards direction.

WARNING: The rear lid will drop down if it is not supported.

Fig 1: Pulling Off Tension Spring With Damper

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook tension spring with damper (1) from rear lid hinge (2).

Fig 2: Identifying Tension Spring With Damper And Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe installation direction: hinge end is identified by means of plastic sleeve (1).

Following parts on the tension spring with damper must not be damaged or missing:

Plastic sleeve
Foam inlay in tension spring

Fig 3: Identifying Plastic Sleeve And Foam Inlay In Tension Spring
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Semicircular rubber buffer (2) (from window repair kit) must be fitted to rear lid hinge (3) without end stop (1).

Stick semicircular rubber buffer (2) at spacing (A) on rear lid hinge (3).

A = 65 mm

Semicircular rubber buffer (2) must touch rear lid hinge (3) in area (4) with rear lid open.

Fig 4: Identifying Rubber Buffer And Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.