41 61 014 Adjusting Engine Compartment Lid

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of BODY, GENERAL .

The specified BODY GAP DIMENSIONS serve as the basis for adjustment tasks.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: Carry over schematic representation to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Hood lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Fig 1: Identifying Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must snap correctly into place.

Adjust engine hood.

NOTE: HEIGHT ADJUSTMENT of engine hood to side panel by means of stop pads.

Fig 2: Vertical Adjustment Of Engine Hood To Side Panel By Means Of Stop Pads

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of bonnet to front wall:
Release screw (1) and remove cover (2).
Height adjustment by turning at closing hooks (3).

Fig 3: Identifying Screw, Cover And Hooks

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down all screw connections again.

Tightening torque: see 1AZ in 41 61 ENGINE BONNET/HOOD

IMPORTANT: Check function of retaining hook.