41 00... Installing Cavity Sealing (Not Expanded)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry over schematic representation to the relevant vehicle type.
The following repair represents the procedure for an already expanded cavity bulkhead.
Before these work steps, prepare the new part so that it is ready to install (adapting, cutting to size, applying welding primer etc.).
Sand contact surface of cavity sealing (1) with coarse-grained sandpaper (grain 50-100).
Clean contact surface (1) with cleaning agent R2.
If necessary apply SEALANT D1 somewhat thinner on each side, to prevent the sealant from running.
Attach cavity sealing in specified position (see used part).
Fit, secure and weld up new part.
WARNING:
Ensure adequate ventilation over entire processing period.