63 12 010 Removing and installing/replacing left headlight (xenon headlight)

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS)

Unclip strip (1) in direction of arrow.

Release screws (2) underneath.

Fig 1: Unclipping Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Turn cap (1) approx. 30° counterclockwise and remove from headlight (2).

Fig 2: Turning Headlight Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1)

Unfasten screws (2).

Installation:

Observe BODY GAP DIMENSIONS .
Adjust HEADLIGHTS

Fig 3: Identifying Screws (1)
Courtesy of BMW OF NORTH AMERICA, INC.

Pull bumper panel (1) forwards slightly and feed out headlight (2) in direction of arrow.

Installation:

Make sure headlight (2) is correctly seated in lower holder.

Unlock and disconnect associated plug connections (3).

Remove headlight (2).

Fig 4: Pulling Bumper Panel Forwards

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip headlight holder (1) and remove.
Remove IGNITION UNIT AND BULB FOR XENON HEADLIGHT (2) .
Remove CONTROL UNIT FOR XENON HEADLIGHT (3) .

Fig 5: Identifying Headlight Holder And Control Unit For Xenon Headlight
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs (1) on headlight holder (2) must not be damaged.

Make sure headlight holder (2) is correctly engaged on headlight.

Fig 6: Identifying Retaining Lugs On Headlight Holder

Courtesy of BMW OF NORTH AMERICA, INC.