33 32 Control Arms And Struts
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
CONTROL ARMS AND STRUTS - TORQUES SPECIFICATION TABLE
| - | Type | Thread | Tightening specification | Measure |
|---|---|---|---|---|
| 1AZ Trailing arm to rear axle carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace nut tighten in normal position |
100 Nm |
| 2AZ Trailing arm to wheel carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace nut tighten in normal position |
100 Nm |
| 3AZ Control arm to rear axle support | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace nut tighten in normal position |
100 Nm |
| 4AZ Traction strut to wheel carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace screw tighten in normal position |
- |
| - | - | - | Jointing torque | 100 Nm |
| - | - | - | Torque angle | 90° |
| 5AZ Control arm to rear axle carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace nut tighten in normal position |
100 Nm |
| 6AZ Control arm to wheel carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace screw tighten in normal position |
- |
| - | - | - | Jointing torque | 100 Nm |
| - | - | - | Torque angle | 90° |
| 7AZ Toe arm to rear axle carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | Replace nut tighten in normal position |
100 Nm |
| 8AZ Toe arm to wheel carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M12 | tighten in normal position | 100 Nm |
| 9AZ Camber arm to rear axle carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M14 | Replace nut tighten in normal position |
165 Nm |
| 10AZ Camber arm to wheel carrier | E81, E82, E87, E88, E90, E91, E92, E93 | M14 | Replace nut tighten in normal position |
165 Nm |
| 11AZ Tension strut to body | E81, E82, E92/Except S65 | M8 | - | 24 Nm |
| 12AZ Tension strut to compression strut | E81 | M12 | Jointing torque | 56 Nm |
| - | - | - | Torque angle | 90° |
| - | E82, E92/Except S65 | M12 | Jointing torque | 100 Nm |
| - | - | - | Torque angle | 90° |