72 11 092 Removing and installing/replacing rear left or right seat belt
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear seat , see 52 26 001 REMOVING AND INSTALLING/REPLACING BOTH REAR SEATS .
- Remove panel for roof pillar , see 51 43 259 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR ROOF PILLAR (D-PILLAR), LEFT OR RIGHT .
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release screw (1) on end fitting.
Installation:
Replace screw.
Tightening torque: 72 11 21AZ , see 72 11 SEAT BELTS .
Installation:
End fitting is coded against incorrect assembly.
Release screw (1).
Installation:
Replace screw.
Tightening torque: 72 11 20AZ , see 72 11 SEAT BELTS .
Remove inertial reel mechanism (2).
Installation:
Inertia reel mechanism (2) is coded against incorrect installation.