Airbag plug connection on gas generator/airbag module offset by 90°

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

There are two ways of unlocking this airbag plug connection on the gas generator/airbag module:

Method 1:

Simultaneously pull cover (1) upwards at lugs on left and right (2).

Fig 1: Unlocking Airbag Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Method 2:

Insert a narrow screwdriver into recess (1) in housing (2).

Carefully prise cover (3) off (4).

Fig 2: Unlocking Airbag Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Cover (1) is not positioned higher than housing (2).

The airbag plug connection is unlocked and can now be detached from the gas generator/airbag module.

Fig 3: Identifying Cover And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

After attaching airbag plug connection to gas generator/airbag module, press cover (1) downwards until it rests flat on housing.

Check that it catches properly.

Fig 4: Pressing Cover Downwards

Courtesy of BMW OF NORTH AMERICA, INC.

Lock button
Gas generator

Fig 5: Identifying Initial And Final Engagement Position
Courtesy of BMW OF NORTH AMERICA, INC.

Version 4 - Crash-active head restraint:

Press locking clip at edge and disconnect plug (1).

Installation:

Check for correct engagement.

Fig 6: Pressing Locking Clip At Edge
Courtesy of BMW OF NORTH AMERICA, INC.