67 32 600 Replacing fan for front seat surface (comfort seat)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
US/CDN front passenger seat (with OC3 mat) only:
If seat cover is defective, seat cover, padding and OC3 mat must be replaced together.
The same applies to a faulty OC3 mat or padding. Both parts can only be replaced together with the seat cover.
New seat cover is supplied with padding, OC3 mat and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
If seat cover is defective, seat cover, padding and OC3 mat must be replaced together.
The same applies to a faulty OC3 mat or padding. Both parts can only be replaced together with the seat cover.
New seat cover is supplied with padding, OC3 mat and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
Necessary preliminary tasks:
- Remove front seat , see 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT .
- Partially remove cover for front seat , see 52 14 400 REPLACING COVER FOR LEFT OR RIGHT FRONT SEAT .
NOTE:
For purposes of clarity, illustration shows seat padding and seat cover removed.
Lift dividing net (1), pull fan for seat surface (2) out of seat padding (3) slightly and disconnect plug connection behind.
Remove fan for seat surface (2).