66 53 010 Calibrating reversing camera (from 10/2009)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjustment of rear lid
IMPORTANT:
Follow instructions and specifications in test module.
To obtain an optimum result, always adhere to the following conditions:
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Correct tire inflation pressure (see instruction plate on car).
- Vehicle is free of load
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system. Use of a special tool is no longer required from 10/2009!
Service functions: Complete vehicle, Driver assistance, Reversing camera.