66 20 518 Removing and installing/replacing a front ultrasonic transducer (center)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front bumper trim , see 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .

Disconnect plug connection (1) and unclip ultrasonic transducer from retaining tabs (2).

Installation:

Retaining tabs (2) must not be damaged!

Make sure ultrasonic transducer is securely seated.

Fig 1: Identifying Plug Connection And Retaining Tabs - Front Ultrasonic Transducer (Centre)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure rubber ring (1) is correctly seated on ultrasonic transducer (2).

Fig 2: Identifying Rubber Ring On Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.