66 20 516 Removing and installing/replacing a front right ultrasonic transducer

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

N54: Remove front bumper trim , see 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
M57T2: Remove grille in bumper trim at front left , see 51 11 185 REMOVING AND INSTALLING/REPLACING GRILLE (SIDE) IN BUMPER TRIM .

Disconnect plug connection (1).

Unlock catches (2) and remove ultrasonic transducer from holder.

Installation:

Make sure electrical lead (4) is correctly guided in cable fastener (3).

Fig 1: Identifying Plug Connection, Catches And Electrical Lead

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure rubber ring (1) is correctly seated on ultrasonic transducer (2).

Fig 2: Identifying Rubber Ring On Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.